IST On-line

• Alumnium case coated with matte black finish and has no-tip feet. Non-glare, shatterproof, transparent red plexiglass lens.
• Includes bracket to mount to wall
• Built in Piezo horn
• Includes 24V AC wall transformer (connect only to GFI outlet). Battery model includes two internal, rechargeable 12V batteries with an over/undercharge protection circuit.
• 4 character display plus colon - displays up to 99 minutes, 59 seconds.
• Characters are 6.5" x 4.5" formed by clusters of Super-bright, red LED's for indoor or outdoor use
• LED's guaranteed by manufacturer for 100,000 hours of continuous use.
• Controlled with a programmable pendant.( 7.5" x 4" x 1.2", .6lbs ) with waterproof membrane switch keypad and  impact-resistant ABS plastic case. Features Workout, E-Z Workout, Game, Stopwatch and Manual Modes.

• Alumnium case coated with matte black finish and has no-tip feet. Non-glare, shatterproof, transparent red plexiglass lens.
• Includes bracket for mounting to wall
• Built in Piezo Horn
• Includes 24V AC wall transformer (connect only to GFI outlet).
• 4 character display plus colon - displays up to 99 minutes, 59 seconds.
• Characters are 6.5" x 4.5" formed by clusters of Super-bright, red LED's for indoor or outdoor use
• LED's guaranteed by manufacturer for 100,000 hours of continuous use.
• Counts continuously from 0:00.00 to 0:59.99 when turned on, then repeats.
• Can be linked to SWIMCLOCK's to run the same program using cables available from IST.
• Can be upgraded to programmable by adding a prgramming pendant. 

• Case consists of an aluminum extrusion coated with a matte black anodized finish.  End caps flare at bottom to form no-tip feet.
• Includes bracket for mounting to wall
• Lens is transparent red, 1/8”, non-glare shatterproof Plexiglas.
• Built in Piezo horn.
• All models should only be connected to GFI (Ground Fault Interrupt) 110V 5 amp (min.) outlet.
• When connected to the POLOWARE Interface and a PC running POLOWARE Software, the SHOTCLOCK gets its power from the Interface through the data cable and does not need to be plugged into an outlet.
• Two character display, which displays up to 59 seconds.  Characters are 6 1/2" x 4 1/2" .
• Each character is formed by a matrix of dots, 7 high by 5 wide.  Each dot is formed by a cluster of 4 red Super-Bright Light Emitting Diodes (LED’s), guaranteed by their manufacturer for 100,000 hours of operation.
• When connected to the POLOWARE Interface and a PC running POLOWARE Software, the SHOTCLOCK is controlled by POLOWARE for water polo games.  When the preset time expires, a loud tone sounds.  For more information on POLOWARE, see the specification for that product.
•  SHOTCLOCK can be controlled though the optional Programming Pendant.
• If pendant is not attached, the SHOTCLOCK will begin counting by seconds continuously from 0:00 to 00:59, then repeat.
• Multiple SHOTCLOCK’s can be linked together and programmed with one Programming Pendant to run synchronously.

• Keypad is 16-key waterproof membrane switch. Keys are 0-9, Start/Stop, Clear, Enter, Exit, Up and Down.
• Display is 4 row by 16 character back lit alphanumeric LCD measuring 2.5" x 1"
• Case is impact-resistant ABS plastic.
• Recieves power from the pace clock through a 5' coiled 6-conductor wire with RJ11 connectors. 
• Operation features:
  
  1. WORKOUT MODE: create up to 30 sets, each containing up to 5 intervals with up to 99 repetitions. Count-up or count-down is selectable. Sets are retained in memory by number and can be recalled at any time. Up to 15 workouts can be created, each containing up to 30 sets. Up to 99 send-off tones can be included with a selectable interval of from 1 to 9 seconds. Workouts are retained in memory by number and can be recalled at any time. While running, workouts can be stopped, restarted or reset.

2. E-Z WORKOUT: Allows the operator to enter a time interval and a number of repetitions. Once started, the clock will run until all repetitions have been completed.

3. GAME MODE: Allows the operator to set a time and select either count-up or count-down. While the clock is running, it may be stopped and restarted or reset. A tone sounds when time is expired. Multiple clocks can be linked to run synchronously (see Section I, E, 2).

4. STOPWATCH MODE: Allows clock to be used like a stopwatch in Free Running, Cumulative or Lap modes. Free Running mode allows the operator to start, stop and reset the clock to zero. Cumulative mode allows split stops and displays cumulative splits. Lap mode displays lap splits each time the Enter button is activated.

5. MANUAL MODE:  If the programming pendant is not attached, the SWIMCLOCK will begin counting up from zero a few seconds after it is turned on.  It will count continuously to 99 minutes 59 seconds and then repeat.